ME 109 wrote:Kurt, do you think there is any concern with the fuel bowl measurement as the bowl is removed from the carb?
That is to say that the fuel in the fuel line below the Petcock will flow into the bowl as it is lowered from the carb.
Perhaps it is an insignificant amount.
Duane Ausherman wrote:One can get a good estimation of float bowl level without any measurement at all. Remove the bowl and raise the float by hand until it just barely touches the needle. The casting line on the float should be parallel with the bottom of the carb body casting.
Users browsing this forum: No registered users and 1 guest