Boxerworks.com

Thanks for all your advise I think I shall start by stripping them down an clean every thing up fit some new BMW seals as they are were probably the cheapest about when they were replaced and rebuild checking the alignment is correct as I go. Also thinking about I never noticed any problem for the m...

I found that the fork sliders would not drop separately under there own weight before I putting in the spring and oil or spindle and mud guard. This is why I wanted strip them down and see if there are any improvements around or any tips on putting them back together or anything prone to wear. Is it...

Hi I will be replacing the fork seal soon and cleaning the internals as the forks take a bit of force before they start to move "sticktion". I have read an article that there were some BMW updates to the forks internals until they moved to the monoshock bikes. I was wondering if any one fi...

On the Metzeler site they state 2.1 bar front 2.3 rear. I would start there and fine tune up or down if there was an improvement

Phil

Thank for that Barry Looks like a job for this winters service


Phil

chas Barry
I have a 1982 r100rs an have that clunk on low speed bump where can iI find info on the mods

Phil

This link shows a relay mod that could work on an airhead.

http://www.ebbo.org/headlamp_relays.php


Phil