charging system fault finding

Discuss all things 1970 & later Airheads right here.
Kurt in S.A.
Posts: 1647
Joined: Tue Aug 03, 2010 12:08 pm

Re: charging system fault finding

Post by Kurt in S.A. »

Just about any decent 12v regulator would be better than the 1970s OEM one. I installed a Transpo brand regulator on my /7 years ago. The IBMWR site has substitutes...they list several regulators:

https://ibmwr.org/index.php/bmw-parts-substitutes/

Kurt in S.A.
Rob Frankham
Posts: 1214
Joined: Thu Aug 26, 2010 2:11 pm
Location: Scotland UK, 20 miles from civilisation up a dead end road!
Contact:

Re: charging system fault finding

Post by Rob Frankham »

The solid state regulators fitted by BMW are perfectly adequate... the mechanical ones work quite well. There is a myth that a higher charge voltage and rate is automatically a good thing. This is not the case. In fact, to a certain extent, the lower the charge rate the better it is for the battery provided it meets the requirements of the end use application (the bike electrics).

There is also a myth that a different regulator can somehow increase the maximum output of an alternator. This is also not the case. The ability of the alternator to produce electricity is dependant on the alternator alone. The regulator only reduces the output to that required by the bike.

In essence, there is no need to replace the regulator unless it is in some way defective... unless, as I say, the bike is used mainly for very short journeys in which case a regulator with a slightly higher limiting voltage can be used to make a small benefit in the time taken for the battery to achieve full charge.

In seeking a replacement, I would always go for one from a reputable and well estasblished manufacturer rather than from a bike accessory firm mainly on the grounds of reliability and accountability...

Rob
ImageImageImage
Post Reply