Pull Back ?
Rise ?
I gues we have lost this information again ... or my search words were inadequate.
"S" handlebar dimensions needed
"S" handlebar dimensions needed
Tip to Tip ?
Pull Back ?
Rise ?
I gues we have lost this information again ... or my search words were inadequate.
Pull Back ?
Rise ?
I gues we have lost this information again ... or my search words were inadequate.
Some of the above is fact, some is fiction, some is my personal imagination and some is just simple truth. [me]
http://www.stephenbottcher.net
http://www.stephenbottcher.net
Re: "S" handlebar dimensions needed
1955 to 73 low bars from Motobins.
CS standard bars from Motobins
Fehling S bars from Huckey's
I would be keen to know the measurments of the factory installed Magura bars. I had a set on my old /7 and they where super comfey. Much better than the 55 to 73 low bars.
- 61010.jpg (5.09 KiB) Viewed 528 times
- 61012.jpg (16.65 KiB) Viewed 528 times
- 32712303042F.jpg (6.13 KiB) Viewed 528 times
Garnet
Re: "S" handlebar dimensions needed
These are what I have -
Height:
3"
Pullback:
4.75"
Center:
4"
Width:
25.25"
http://www.sideroadcycles.com/ImportedM ... raBMW.html
Height:
3"
Pullback:
4.75"
Center:
4"
Width:
25.25"
http://www.sideroadcycles.com/ImportedM ... raBMW.html
I've spent most of my money on women, motorcycles, and beer.
The rest of it I just wasted.
The rest of it I just wasted.