Boxerworks.com

Posted: **Thu Apr 09, 2020 6:56 am**

Hi Rob.

I assumed this was correct as I installed it in the way I removed it.

Please educate me on how to set the timing? I don't have a timing light though.

I see in the manual that I need to rotate the distributer counter or clockwise to advance and retard respectively. What position is static. In the middle of the slotted area?

Posted: **Thu Apr 09, 2020 7:42 am**

Try this...
Basic static timing.

If you don't have a suitable timing light, initial timing can be done as follows:
• loosen the two screws holding the 'bean can'.
• set the engine to point where the timing mark is aligned.
• remove the plugs and connect them to the HT leads then ground the plug bodies so you can see the spark.
• switch on the ignition, don't start the bike.
• turn the 'bean can' gently in its housing till you see the spark stopping immediately you see it.
• tighten the 'bean can' screws.
This sets the timing adequately to achieve engine start.
The final setting should be done using a strobe.

Boxerworks.com

1983 R65LS complete rebuild first start

Re: 1983 R65LS complete rebuild first start

Re: 1983 R65LS complete rebuild first start