Boxerworks.com

PAS wrote: ↑Tue Oct 27, 2020 9:09 am Thats my picture from adriders.

Yep. I got the trans out. That screw is tight. There's a bit more dirt and a little moisture on the shelf under the RMS than I wanted to see. Spline looks ok. Dry, needs some moly.

The drip gutter is thin sheet metal. The part found looks to thick for that...but it's pretty mangled. The original image has a ruler beside it which I'm assuming is metric which is where I get the size of about 20mm. I would be very reluctant to hazard a guess on what it is but given the other symptoms of slippage, I think it's a fair bet there's something pretty fundamentally wrong with the box...

Rob

gspd wrote: ↑Tue Oct 27, 2020 12:39 pm If you can clean that piece up, and post clear varying angle pics of it, with a metric ruler for scale, I'm confident I can tell you what it is.

Here ya go. Waddya think?

Steve check your Private message.

Looks like something that was intentionally put in the gearbox.

I have a disassembled gearbox and I dont see anything that could end up like that inside.

PAS wrote: ↑Wed Oct 28, 2020 9:06 am Looks like something that was intentionally put in the gearbox.

It sure looks unusual. This trans was renovated ~ 140Kkm back. The bikes done ~ 275Kkm now. It's worked beautifully since. It's been securely parked in my shed during our lockdown.

Have you discovered what's causing the (lack of) transmission problem yet?

Rob

I would think it would have gear marks all over it if it was being "run thru the mill"!