Page 6 of 6
Re: Removing an intake port
Posted: Thu Jan 06, 2011 9:33 pm
by ME 109
SteveD wrote:
Rocker cover is upside down or wrong side...I forget!
Excellent work though.
Upside down is OK (other than it shows off the scrape marks
)
Wrong side is what will give the fins that 'sloping' look.
It may be the angle of the dangle of the photo in this case tho'?
Re: Removing an intake port
Posted: Thu Jan 06, 2011 9:38 pm
by Major Softie
ME 109 wrote:SteveD wrote:
Rocker cover is upside down or wrong side...I forget!
Excellent work though.
Upside down is OK (other than it shows off the scrape marks
)
Wrong side is what will give the fins that 'sloping' look.
It may be the angle of the dangle of the photo in this case tho'?
Yep, wrong side. Being up on the centerstand actually makes straightens them a little. They'll look even worse off the stand.
Re: Removing an intake port
Posted: Fri Jan 07, 2011 5:53 am
by ME 109
Major Softie wrote:Yep, wrong side. Being up on the centerstand actually makes straightens them a little. They'll look even worse off the stand.
Hey Kurt, do you know so just like the way I know so?
Re: Removing an intake port
Posted: Fri Jan 07, 2011 10:16 am
by Steve in Golden
Major Softie wrote:Yep, wrong side. Being up on the centerstand actually makes straightens them a little. They'll look even worse off the stand.
I think he likes 'em that way. A few years back, I bought a '78 R100/7 ("The Mule") from RapidDog (BTW how the hell are ya Randy?) and the valve covers were on the wrong sides.