Page 1 of 1
Tommaselli Daytona Throttle
Posted: Thu Mar 23, 2017 2:11 pm
by hudson
Hey guys - I have an 71 R75/5 and thinking of replace the OEM throttle unit on my R75/5 with the Tommaselli Daytona 2CThrottle- less fuss, no grease, etc. It fits 22mm (7/8) bars. It doesn't appear that the cables would have to be changed, but perhaps I am mistaken. Has anyone switched over? Any problems, any input? Thanks.
BTW, I have Mikuni carbs if that makes a difference.
Re: Tommaselli Daytona Throttle
Posted: Thu Mar 23, 2017 4:40 pm
by Bamboo812
22mm and 7/8" are not the same thing...
Re: Tommaselli Daytona Throttle
Posted: Fri Mar 24, 2017 2:16 am
by Zombie Master
Bamboo812 wrote: ↑Thu Mar 23, 2017 4:40 pm
22mm and 7/8" are not the same thing...
+1
Re: Tommaselli Daytona Throttle
Posted: Fri Mar 24, 2017 9:00 am
by jagarra
22 mm= .866, 7/8 = .875. If my calculations are correct. Enough to keep perches from going on easily.
Re: Tommaselli Daytona Throttle
Posted: Fri Mar 24, 2017 9:13 am
by dougie
Zombie Master wrote: ↑Fri Mar 24, 2017 2:16 am
Bamboo812 wrote: ↑Thu Mar 23, 2017 4:40 pm
22mm and 7/8" are not the same thing...
+1
+2
(BTDT)
Re: Tommaselli Daytona Throttle
Posted: Fri Mar 24, 2017 1:18 pm
by Bamboo812
jagarra wrote: ↑Fri Mar 24, 2017 9:00 am
22 mm= .866, 7/8 = .875. If my calculations are correct. Enough to keep perches from going on easily.
The Tommasellis will be loose on a 22mm bar.
Re: Tommaselli Daytona Throttle
Posted: Mon Mar 27, 2017 9:33 am
by hudson
Ok, appreciate it. Was basing it on the input from an aftermarket parts dealer. Glad to know before I ordered it. Thanks!