Page 1 of 1
Krauser 4v Valve Clearances
Posted: Sun May 22, 2011 8:04 pm
by rallyfan1
Hey I am new and just registered to this site because it looked like a good place to get some valuable info. I am looking for but have been unable to find the proper valve clearances for Krauser 4v heads. They are on a '77 100rs. Would anyone know what these would be or know a good source of Krauser information? Thanks!
Re: Krauser 4v Valve Clearances
Posted: Mon May 23, 2011 1:02 am
by vanzen
Adjusted
WARM
Intake: 0.1 mm
Exhaust: 0.1 mm
... and the
Krauser 4V manual,
courtesy of
John's Beemer Garage
Re: Krauser 4v Valve Clearances
Posted: Tue May 24, 2011 2:39 pm
by Krauser4valve
rallyfan1 wrote:Hey I am new and just registered to this site because it looked like a good place to get some valuable info. I am looking for but have been unable to find the proper valve clearances for Krauser 4v heads. They are on a '77 100rs. Would anyone know what these would be or know a good source of Krauser information? Thanks!
Take a look at this video, me-thinks that parts of the Krauser valve train were stock BMW auto bits.
http://www.youtube.com/watch?v=_ubwFXgU_nM
Re: Krauser 4v Valve Clearances
Posted: Tue May 24, 2011 5:58 pm
by vanzen
I would not hold your breath in the hope of any K4V - BMW auto parts interchangeability ...
However, Willie Roth who headed the Team Krauser BMW car racing effort
was a primary player in the design and engineering of the K4V head.
Besides, the matter of eccentric adjusters is just not all that peculiar !
Re: Krauser 4v Valve Clearances
Posted: Tue May 24, 2011 7:23 pm
by Garnet
vanzen@rockerboxer.com wrote:
Besides, the matter of eccentric adjusters is just not all that peculiar !
Yep, just take a look around here.
Re: Krauser 4v Valve Clearances
Posted: Tue May 24, 2011 8:59 pm
by Deleted User 62
Garnet wrote:vanzen@rockerboxer.com wrote:
Besides, the matter of eccentric adjusters is just not all that peculiar !
Yep, just take a look around here.
I resemble that comment!
Re: Krauser 4v Valve Clearances
Posted: Wed May 25, 2011 3:24 am
by vanzen
Garnet wrote:vanzen@rockerboxer.com wrote:
Besides, the matter of eccentric adjusters is just not all that peculiar !
Yep, just take a look around here. :lol:
Thanks for catching my drift ...
Re: Krauser 4v Valve Clearances
Posted: Mon May 30, 2011 8:47 pm
by rallyfan1
Thanks for the info.