What is it? How does it go back in, it seems like it's hitting a spring or something of the sort
SOS R1100gs pulled out bolt on back of block, won't go back in
SOS R1100gs pulled out bolt on back of block, won't go back in
Went to do a speedy oil change and pulled out this bolt thi king it was the drain without hesitation 
What is it? How does it go back in, it seems like it's hitting a spring or something of the sort
What is it? How does it go back in, it seems like it's hitting a spring or something of the sort
- Attachments
-
- 20250501_131444.jpg (1.28 MiB) Viewed 675 times
Re: SOS R1100gs pulled out bolt on back of block, won't go back in
Found a post that this is the chain tensioner and put it back in the hole in the bottom. Seemed alright. Figured I should pull the wrong bolt out on the other side too for good balance...
It went right back in but the bike won't idle now. I assumed this was just to keep tension on a guide. I've searched up and down and can't find it on any diagram. Any insight would be helpful. Thanks
It went right back in but the bike won't idle now. I assumed this was just to keep tension on a guide. I've searched up and down and can't find it on any diagram. Any insight would be helpful. Thanks
Re: SOS R1100gs pulled out bolt on back of block, won't go back in
Pic attached
- Attachments
-
- 20250501_151640.jpg (1.4 MiB) Viewed 657 times
Re: SOS R1100gs pulled out bolt on back of block, won't go back in
I'm parked on ground that isnt level so it's possibly I'm under filled , would that cause the bike to stumble and shut off when cold? If anyone can even tell me the name of the part between the (head&block?) That would give me somewhere to start.