Handlebar Master

[Norm T R100T R1150RT]

Gatherin an assortment of parts to do a conversion from the undertank - purchased a double banjo bolt - 10mm x 1.25 Double Bleed - length is good, thread size is too coarse - what is the proper designation / size to get the correct thread pitch ? Thanks

[jagarra]

The other size I have seen is 10 x 1.0 mm.

[George Ryals]

https://www.belmetric.com/metric-banjo- ... 9ldgchkti2

[jagarra]

Here's one with free shipping.

http://www.ebay.com/itm/Goodridge-Banjo ... ru&vxp=mtr

[Norm T R100T R1150RT]

Thanks for the responses - my confusion was with the thread "pitch" - 1.25 coarse - 1.0 fine thread (I'm a hopin) - thanks again - I'll be back with more later - need to source the one into two cable set-up also - plan on new cables but I'll try to find the rest used - all them little parts add up

[jagarra]

When you replace cables, it's best to go with the OEM ones from the dealer. They are better built and are Teflon lined for smoothness. I just bought new under tank brake cable and throttle cables, price was not that bad for the quality.
I have a set of after market units, they just don't measure up as well, they went back into the spares pile.

[Norm T R100T R1150RT]

New OEM cables definitely - lookin to get the gizmo that joins the cables used if I can - not in a hurry, hopefully one will show up on ebay - thanks for the advice